217V-085-M9254F Pump Head Kit with motor includes parts below:

	Pumptec 217V Pump Head Only 60063 (Side Ports) Kaivac Please note to use as a replacement on a Kaivac you will have to re-use the pump front face plate off the original pump. Note the original is a 2 port head and this is a side port in and out connection.   The front place is easy to change out by just removing the two bolts on the rear of the pump head.  Compare to Kaivac PM217
	Pumptec: Repair Kit "C" Cam Bearing for 400-500 Psi Models 204V, 205V, 207V, 217V .095 Stroke Replaces 0100-6005-0095
	Pumptec: M9254F 240Volt Motor Only Replaces the Old M53
	Bridge Rectifier for Edic, PumpTec, Burnishers, & More
	Pumptec Kit, Base Mounting Plate / Bracket For M20/M53/M54 Motors

Note: to use in a Kaivac cleaning machine you just un-bolt the front head and re-use the front head face plate from your original pump. 
This way the water goes in and out through the front and not the sides. 
This is super easy to do, as you just remove the head from the motor and then remove the two bolts on the back of the pump to remove the front face plate off the pump. 
The above procedure will save you over $200 over purchasing the same pump with the pre-drilled and tapped holes in the front of the pump.

Compare to: 10679065071972

Part Number	81482
Max Pressure (psi)	500
Open Flow (gpm)	1.5
Seals	V-Ring
O-rings	Buna
Plunger	305 SS
Inlet Ports	(2) - 1/4" NPT (F)
Discharge Ports	(2) - 1/4" NPT (F)
Max Fluid Temp. (℉)	140
RPM	2000
Body	Anodized Aluminum
Valves	Stainless Steel
Color	Gold
Fasteners	Stainless Steel

Optional

Convert your 500 psi carpet cleaning machine into a tile cleaning machine. Clean Storm Rhino Grout Master Cleaning Tile Cleaning Tool 300psi - 1200 psi Edging Wand 20190919  Videos On Link!