FOSTERS 40-51 MOLD RESISTANT CLEAR COAT - 5 gallons


This coating is designed as a clear coat for long-term protection against mold and mildew other odor-causing bacteria. Color is clear.



MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
PHYSICAL STATE: Liquid
COLOR: White
ODOR: Sweet Mild
ODOR THRESHOLD: Not established
WEIGHT PER GALLON (lbs.): 8.8
SPECIFIC GRAVITY: 1.06
pH: 9.4
FLASH POINT: Non flammable
BOILING POINT (deg. C): Not established
FREEZING/MELTING POINT (deg. C): Not established
VAPOR PRESSURE (mm Hg): Not established
VAPOR DENSITY: Not established
EVAPORATION RATE: Not established
OCTANOL/WATER COEFFICIENT: Not established
VOC, weight percent Not determined
SECTION 10: STABILITY AND REACTIVITY
STABILITY: Stable under normal conditions.
CHEMICAL INCOMPATIBILITY: Not established
HAZARDOUS POLYMERIZATION: Will not occur.
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide, carbon dioxide Sulfur containing
gases Nitrogen containing gases
SECTION 11: TOXICOLOGICAL INFORMATION
COMPONENT LD50/LC50
Zinc compounds Oral LD50 Rat = 177 mg/kg
Inhalation LC50 Rat = 140 mg/cu m (no duration specified)
Dermal LD50 Rabbit = 100 mg/kg
TOXICOLOGY SUMMARY: No additional health information available.
SECTION 12: ECOLOGICAL INFORMATION
OVERVIEW: No ecological information available
SECTION 13: DISPOSAL CONSIDERATIONS
To the best of our knowledge, this product does not meet the definition of hazardous waste under the U.S. EPA
Hazardous Waste Regulations 40 CFR 261. Solidify and dispose of in an approved landfill. Consult state, local or
provincial authorities for more restrictive requirements.
SECTION 14: TRANSPORTATION INFORMATION
Consult Bill of Lading for transportation information.
DOT: NOT REGULATED
IATA: NOT REGULATED
SECTION 15: REGULATORY INFORMATION
INVENTORY STATUS
U.S. EPA TSCA: This product is in compliance with the Toxic Substances Control Act's
Inventory requirements.
CANADIAN CEPA DSL: This product contains a component that is not on the DSL. If you are the
importer of this product into Canada, contact H.B. Fuller for chemical
tracking and notification information.
826078PM Page 4 of 4
04-09-2009
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
EUROPEAN EINECS: As a result of the introduction of REACH into Europe, this product cannot be
imported into Europe unless the REACH requirements are met.
If you need more information about the inventory status of this product call 651-236-5858.
This product may contain chemical substances that are regulated for export by various government agencies (such as
the Environmental Protection Agency, the Bureau of Industry and Security, or the Drug Enforcement
Administration, among others). Before exporting this product from the USA or Canada, we recommend you contact
us at 651-236-5858 (USA) or 450-655-1306 x227 (Canada) to request an export review.
FEDERAL REPORTING
EPA SARA Title III Section 313
Unless listed below, this product does not contain toxic chemical(s) subject to the reporting requirements of section
313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA) and 40 CFR part 372. EPA
has advised that when a percentage range is listed the midpoint may be used to fulfill reporting obligations.
Chemical Name CAS# %
Zinc compounds 13463-41-7 1 - 5
WHMIS STATUS: Unless listed below, this product is not controlled under the Canadian Workplace Hazardous
Materials Information System.
STATE REPORTING
This MSDS is not prepared for distribution in California.
SECTION 16: ADDITIONAL INFORMATION
This Material Safety Data Sheet is prepared to comply with the United States Occupational Safety and Health
Administration (OSHA) Hazard Communication Standard (29 CFR 1910.1200) and the Canadian Workplace
Hazardous Materials Information System (WHMIS).
HMIS RATING: HEALTH -- 0 FLAMMABILITY -- 0 REACTIVITY -- 0
See SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION for personal protective equipment
recommendations.
Prepared by: The Global Regulatory Department
Phone: 651-236-5842
The information and recommendations set forth herein are believed to be accurate. Because some of the information
is derived from information provided to Specialty Construction Brands, Inc. from its suppliers, and because
Specialty Construction Brands, Inc. has no control over the conditions of handling and use, Specialty Construction
Brands, Inc. makes no warranty, expressed or implied, regarding the accuracy of the data or the results to be
obtained from the use thereof. The information is supplied solely for your information and consideration, and
Specialty Construction Brands, Inc. assumes no responsibility for use or reliance thereon. It is the responsibility of
the user of Specialty Construction Brands, Inc. products to comply with all applicable federal, state and local laws
and regulations.