Viper Spinergy Diamond 8 Inch Monkey Pads 1500 Grit Case Of 5 These pads are meant to be used to remove wear and achieve a wide variety of finishes from dull hone (no shine) to a high polish on Marble, Travertine or Limestone floors, walls or counter tops with little to no lippage (uneven tiles).
MARBLE POLISHING MADE SO EASY, A MONKEY COULD DO IT!
Finally there’s an effective solution to marble polishing that you can start using immediately to hone and polish most any Marble, Travertine, Limestone or Terrazzo floors, walls, or counter tops.
Never Polished Marble??? Now You Can Polish Like A Pro!
For hundreds of years marble polishing has been an extremely specialized field. Because of the complex nature of natural stone there have been hundreds of polishing methods and compounds used to transform a dull rock into a beautiful highly polished surface. Until now, only a skilled craftsman could even begin to understand which methods and compounds should be used to polish and maintain different marbles. *Patent Pending These pads are meant to be used to remove wear and achieve a wide variety of finishes from dull hone (no shine) to a high polish on Marble, Travertine or Limestone floors, walls or counter tops with little to no lippage (uneven tiles). Follow these simple steps to achieve great results with less mess in less time without the use of harsh chemicals. FOR USE WITH FLOOR MACHINES: 17” - 20” (175-350 rpm) 1. Sweep or vacuum to remove all abrasive soils. 2. Clean surface with “Stone Cleaner”. 3. Rinse surface thoroughly. 4. Center “Monkey Pad” on drive plate on floor machine. 5. 175 rpm machines work best with 30 lb drive plate. 300-350 rpm machines do not require extra weight. 6. Apply enough water to 2’ X 5’ area to lightly wet the surface. No need for huge puddles. 7. Move the floor machine in an oval pattern, counter clockwise to keep the water inside the work area. 8. Check surface after 15-30 seconds to see if desired results are achieved. 9. If YES, repeat steps 6-8 on the rest of the room one section at a time. 10. Overlap sections by 4” - 6” to keep an even finish. 11. If NO, repeat steps 7 & 8 until desired result with that grit is achieved (usually 15-45 seconds per 2’ X 5’ area). 12. Rinse whole area between grits. 13. Rinse pad thoroughly after each use and allow to dry. 14. Repeat steps 6-10 with grits as you go to higher number until desired finish is achieved. FOR USE WITH HAND POLISHER: 7” Variable Speed (600-3000 rpm)
“I used these new monkey pads on a travertine honing job and had great results! They are easy to use and easy to clean. I am new to this type of service and am not scared to use them. I believe they are easier than using diamonds and less risky.” Jeff Johnson - Owner, Palace Tile and Stone Restoration - Eugene, OR
