A-Plus Heavy Duty Rotary Turbo Nozzle for HOT Water and 2500 psi

1.  Start turbo nozzles in the downward position and then raise lance to higher level.
2.  Installation can direct onto a lance, with an optional male 1/4" QC Plug, or with an optional filter and plug combination. (see below)  You can even pair more than one together with a "Y" or "T" brass fittings. 
Please note the filter is highly recommended with use on HOT pressure washers as rust in the nozzle with jam up the rotary action. 

     




Question: if my hot pressure washer is set to 240 degrees F, is it OK to use this nozzle?
Answer:  Yes, The water cools down up to 30 degrees through most 100 ft hose runs an this is still OK to use.  The nozzle is designed for water up to 3000 psi @ 212 degrees F at the tip.

Question: What is the difference between the 3000, 4000, and 5100 psi units?
Answer: For the 5100 psi turbo nozzle, it could work in the higher pressure situation and its material is thicker than 3000 psi and 4000 psi turbo nozzle.  5100 psi turbo nozzle's weight is much heavier.  Overall a much longer lasting design with better safety in both hot water situations and higher pressures. The added thickness of the design also makes if better for impact situations if the nozzle hits the ground or some other object.

Question: Can I use this 2500 psi HOT for cold water and low pressure situations?
Answer: Yes

Optional:

Optional Rotary Nozzle Inline Filter High Pressure 1/4in QD X 1/4"Mip Brass 8.709-979.0 Landa Legacy Hotsy Shark 342042  Installs directly into the back of the turbo nozzle and filters rust from water protecting your rotary nozzle.

Optional QD Coupler 1/4" Mip X 1/4 Male Nipple Plug Stainless Steel 8.707-140.0 - Landa Legacy Hotsy Shark  Installs directly into the back of the turbo nozzle for quick coupler action at the end of your lance

Legacy 1/4 Inch Female Socket Quick Coupler X 1/4" Fip Connection 4000 psi 98021640  Used to convert the end of your lance into quick coupler jet and nozzle change out.